Technical data

Setting Up 2
Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 41
Step 2. Connect and set up the oscilloscope
The 2000 X-Series oscilloscope has three different interfaces you can use for
programming:
• USB (device port).
• LAN, when the LAN/VGA option module is installed. To configure the LAN
interface, press the [Utility] key on the front panel, then press the I/O softkey,
then press the Configure softkey.
• GPIB, when the GPIB option module is installed.
When installed, these interfaces are always active.
Using the USB (Device) Interface
1 Connect a USB cable from the controller PC's USB port to the "USB DEVICE"
port on the back of the oscilloscope.
This is a USB 2.0 high-speed port.
Using the LAN Interface
1 If the controller PC is not already connected to the local area network (LAN), do
that first.
2 Contact your network administrator about adding the oscilloscope to the
network.
Figure 1 Control Connectors on Rear Panel
USB Device Port
LAN/VGA
Option Module
GPIB
Option Module