Technical data

:MTESt Commands 21

Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 401

:MTESt:RMODe:SIGMa

(see page 792)

Command Syntax

:MTESt:RMODe:SIGMa <level>

<level> ::= from 0.1 to 9.3 in NR3 format

When the :MTESt:RMODe command is set to SIGMa, the :MTESt:RMODe:SIGMa

command sets the test sigma level to which a mask test runs. Test sigma is the

best achievable process sigma, assuming no failures. (Process sigma is calculated

using the number of failures per test.) The test sigma level indirectly specifies the

number of waveforms that must be tested (in order to reach the sigma level).

Query Syntax

:MTESt:RMODe:SIGMa?

The :MTESt:RMODe:SIGMa? query returns the current Sigma level setting.

Return Format

<level> ::= from 0.1 to 9.3 in NR3 format

See Also • "Introduction to :MTESt Commands" on page 379

• ":MTESt:RMODe" on page 396

Example Code • "Example Code" on page 379