Technical data

:DIGital<d> Commands 12

Keysight InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 247

:DIGital<d>:POSition

(see page 792)

Command Syntax

:DIGital<d>:POSition <position>

<d> ::= 0 to (# digital channels - 1) in NR1 format

<position> ::= integer in NR1 format.

The :DIGital<d>:POSition command sets the position of the specified channel.

Note that bottom positions might not be valid depending on whether digital

buses, serial decode waveforms, or the zoomed time base are displayed.

Query Syntax

:DIGital<d>:POSition?

The :DIGital<d>:POSition? query returns the position of the specified channel.

If the returned value is "-1", this indicates there is no space to display the digital

waveform (for example, when all serial lanes, digital buses, and the zoomed time

base are displayed).

Return Format

<position> ::= integer in NR1 format.

See Also • "Introduction to :DIGital<d> Commands" on page 244

Channel Size Position Top Bottom

Large 0-7 7 0

Medium 0-15 15 0

Small 0-31 31 0

NOTE

This command is only valid for the MSO models.