Specifications

92 VisualSonics Vevo 2100 Imaging System Operator Manual Rev 1.1
Chapter 14: Setting the Presets tab preferences
TIP: Be sure to click the round button, not the row listing. If you click the row listing,
you only display the Mode preset parameters for that application, you do not
actually activate the application. You must click the button beside the row to activate
it as the default.
4. Click OK.
This application remains active until you either disconnect the transducer or
return to the Presets tab and activate a different application.
f To activate the default transducer application:
 Create a new study (page 127)
 Create a new series (page 132)
 Connect a new transducer (page 106)
Applications preferences
A transducer application contains the imaging Mode presets you use to instantly
optimize your image during an acquisition session.
Use the Applications preferences section to create and manage these applications.
Creating a custom application
Each transducer includes factory default applications that contain the imaging
Mode presets you use to instantly optimize your image during an acquisition
session.
You cannot modify these factory default applications. However, you can create
custom applications based on existing applications.
f To create a custom transducer application:
1. From the Study Browser (page 49) click Prefs and click the Presets tab.
2. In the Applications section below the list click New.
3. In the New Application box: