Specifications

72 VisualSonics Vevo 2100 Imaging System Operator Manual Rev 1.1
Chapter 10: Setting the General tab preferences
Auto SAVE preferences
Use the Auto SAVE feature when you want to save a cine loop or an image frame
without using the Cine Store or Frame Store controls.
f To set the system to automatically save an image when you label an
acquired image:
1. From the Study Browser (page 49) click Prefs and then click the General tab.
2. In the Auto SAVE section, set your preference settings as described in the
following table.
Preference Description
Auto SAVE on Image Label Activates the feature. Select the check box.
Image to Auto SAVE
Specifies what type of image the system saves after you label your
image. In the list, select one of the following types:
 Entire Cine Loop
 Current Frame
3. Click OK.
f To Auto SAVE an image when you are scanning:
1. During your image acquisition scan, press
Scan/Freeze
.
2. Press
Image Label
, type the label name and click OK.
The system saves either an entire cine loop or a single frame based on what
you set as your preference in the Auto SAVE section.
3. Press
Scan/Freeze
to continue scanning, or press
Study Management
to see the
listing of the new image in the Study Browser.
Auto SAVE On Scan Completion preferences
Use the Auto SAVE On Scan Completion options when you want the system to
instantly apply the Auto SAVE (page 72) feature when an operator presses
Scan/Freeze
or
Pre Trigger
to complete a scan.
f To set the Auto SAVE On Scan Completion options:
1. From the Study Browser (page 49) click Prefs and then click the General tab.