Specifications

112 VisualSonics Vevo 2100 Imaging System Operator Manual Rev 1.1
Chapter 18: Setting up to acquire physiological data
Preference
Check box selected Check box cleared
BP Derivative
Displays the purple blood pressure derivative
trace line. This data displays the velocity of
change in the BP value.
During imaging, activates the blood pressure
derivative waveform slider control.
Hides the trace line and data.
Dims the waveform slider
control.
Tem p
Displays the Temp trace line (and numerical data
values when you stop imaging) in the
physiological trace window.
Hides the trace line and data.
4. Click OK.
The system applies your settings the next time you begin acquiring image data.
Troubleshoot
If one of the data input options does not appear in the section, it has been
disabled in the Physiological Enable preferences section in the General tab of the
Preferences window.
Related information
 Physiological Enable preferences (page 75)
Physiological Range section
If you are acquiring physiological data, the system can display the data values in
the physiological data window located below the mode data window.
Use the Physiological Range section to optimize the display scale for an
individual trace so you can make the most use of the height of the physiological
display window.
IMPORTANT: You can only optimize the scale for each trace while you are acquiring
data. You cannot optimize the scales when you review an image.
Troubleshooting before you begin
 If an ECG, Respiration or BP slider control is visible but dimmed and you
cannot access it, select the check box for that data stream in the Physiological
Display section at the top of the left panel.
 If an ECG, Respiration or BP slider control does not appear in this section,
enable the check box for the data input in the Physiological Enable
preferences section of the General tab in the Preferences window.