Specifications

Rev 1.1 VisualSonics Vevo 2100 Imaging System Operator Manual 103
Chapter 16: Setting up your Vevo 2100 Imaging System
f To connect the 3D motor stage to the Vevo Imaging Station:
1. Insert the quick release post into the quick release mount located on the
Imaging Station arm.
Quick release mount
Quick release post
2. Carefully line up the holes on the post with the pins on the quick release
mount.
3. Finger tighten the knob on the quick release mount.
4. Connect the 3D motor cable to the 3D Motor connector on the rear panel of
the Vevo 2100 Imaging System.
3D motor connector
Connecting the transducer to the 3D motor stage
When you use the Vevo Imaging Station, you must secure the transducer within
the transducer clamp.
f To connect the transducer to the 3D motor stage:
1. Insert the Quick Release post on the transducer clamp into the Quick Release
mount on the 3D motor stage unit so that the pins on the mount fit into the
holes on the Quick Release post.
2. Tighten the Quick Release mount until it is finger tight.