Operating instructions

9Removing the charts
Remove your chart from the tachograph 1324
• in case of a change of driver or vehicle,
• at the end of the working time
• or after 24 hours at the latest.
1. Press key.
½ The "Ejection active"symbol is shown
in the display. A process indicator sig-
nals that the records on the charts are
being completed by the Tacho-
graph 1324.
½ Wait until the drawer has been
unlocked.
2. Pull out the hinged drawer to the limit
stop and tip it down.
3. Remove the charts and complete the
inscription in the centre field,
➥ see page 18.
4. Bring the hinged drawer into a horizontal
position and push it in until it latches.
Comment
In case you have, however, switched off the
ignition, it is possible that the drawer does
not properly lock after closing. In this case,
please proceed as follows:
1. Switch on the ignition.
½ Wait until the ejection procedure has
been finished.
2. Then push in the drawer until it locks
into place.
3. Switch off the ignition again.
Automatic switching off of the time
group and the distance recording
In case the drawer remains closed with the
charts inserted for more than 25 hours, the
tachograph 1324 automatically records the
time group " " for driver 1 and 2. The
tachograph 1324 thus goes easy on the vehi-
cle batteries.
Notes on a standstill of the vehicle
The drawer may only be opened,
if ...
• the vehicle is at a standstill and
• the ignition is switched on.
Please do not switch off the ignition
while the "Ejection active" symbol is
shown on the display!
If the vehicle will not be used for a
long time, please make sure that
there is no chart in the tacho-
graph 1324; e.g. in case of mainte-
nance or repair work or immobilisa-
tion of the vehicle.