Installation guide

Installation
a) The Monitor
Plug in the VGA monitor cable to the 'SVGA' connector on the terminal rear
panel.
Note: when the terminal is installed in a cabinet or rack, it is essential to
maintain air circulation around both the terminal and the VGA/SVGA monitor.
b) The Keyboard
Connect the USB keyboard to one of the four USB ports. (Located on the
terminal front and rear panels.)
c) The Mouse
Connect the USB mouse to one of the four
USB ports. (Located on the terminal
front and rear panels.)
d) The Network
Plug the network cable into the socket labeled 'NET' on the terminal rear panel.
Note: the terminal network operating mode is indicated by two LEDs located on
each side of the terminal network socket:
-
The green LED on the left: It lights to indicate a satisfactory connection to
the Ethernet circuit (link). If the LED does not light, check that the
Ethernet connector and cable both comply with the specifications listed in
chapter 4.1.
- The orange LED on the right indicates the actual network speed: 10Mb
when the light is off and 100 Mb when the light is on.
e) Other USB Devices
AX3000 Model 80 has four USB
ports as a standard feature. These ports are
located on the front and rear panels of the terminal case.
The USB cables must be shielded and cable length must not exceed 5 meters.
For more information (specifications, electric consumption...), see Chapter 4.
Installation Guide - Model 80
7