Installation guide

Installation

c) Using the Terminal

The terminal is now ready to be used. The cables can be connected to the rear

panel (at the bottom). And the power switch is on the front panel (on the top).

USB Cables Power switch

USB, VGA and Network Cables

2.2.2 - Connecting Cables

For safety reasons and to prevent component damage do not apply power to

the AX3000 before connecting or disconnecting any cables. Do not plug in the

AX3000 power cord until all other connectors have been plugged in.

Make sure the AX3000 and monitor power switches are in the OFF (0) position

before connecting cables to the back panel.

Installation Guide - Model 80