Repair manual

PARTS REPLACEMENT
4-31
L. REPLACING THE POWER SWITCH
1. REMOVAL: (Figure 4-11)
a. Disconnect AC power from the system.
b. Remove the six screws and washers holding the Cover to the bottom of
the chassis (Figure 4-2). Slide the Cover to the rear and off the chassis.
c. The Control Panel is secured to the chassis by two posts and retainers.
Rotate the retainers 1/4 turn and lift them off the posts. Remove the
Contro Panel.
d. Disconnect the leads from the AC Line Filter cable and the power
supply cable.
e. Squeeze the Switch retainer tabs on the inside of the chassis and press
the Switch out of the chassis.
2. INSTALLATION:
Perform steps a. - e. aboove in reverse order.