Repair manual

PARTS REPLACEMENT
4-30
K. REPLACING THE LINE FILTER ASSEMBLY
1. REMOVAL: (Figure 4-10)
a. Disconnect AC power from the system.
b. Remove the six screws and washers holding the Cover to the bottom of
the chassis (Figure 4-2). Slide the Cover to the rear and off the chassis.
c. Disconnect the two Power Switch leands and unsolder the green ground
wire from the Line Filter Assembly.
d. Drill out the pop rivets holding the Line Filter Assembly to the Rear
Cover; remove the assembly.
2. INSTALLATION:
Perform steps a. - d. above, in reverse order.