Repair manual

PARTS REPLACEMENT
4-8
B. REPLACING THE LED
1. REMOVAL: (Figure 4-3)
a. Disconnect AC power from the system.
b. Remove the six screws and washers holding the Cover to the bottom
of the chassis. Slide the Cover to the rear and lift it off (Figure 4-2).
c. Using needlenose pliers, firmly grasp the LED wire leads. Using the
chassis edge as a fulcrum, lever the LED out of its retainer.
d. Unplug the LED cable connector from the Logic Board Assembly.
e. Remove the LED, cable, and connector.
2. INSTALLATION:
a. Feed the LED, from inside the chassis, out through its hole in the
upper left front of the chassis.
b. Plug the LED cable connector into PX on the Logic Board Assembly.
c. Insert the LED into its retainer on the top front edge of the chassis.
d. Replace the Cover (Figure 4-2).