Repair manual

1-8
GENERAL DESCRIPTION
C. Controls and Indicators
The function of each of the controls and indicators shown in Figure 1-3 is described
in Table 1-1.
Table 1-1. Controls and Indicators
Controls Indicators
Front Panel:
Main Power Switch Turns the system on and off.
Front Panel LED When lit, indicates the unit is on.
Control Cable Connector Accepts control cable for powering the
35mm and AutoFilm camera backs.
Rear Panel:
Reset Button Resets the system without powering down.
On newer units, if held in, will provide test
image of color spectrum.
Centronics Parallel Port Accepts parallel interface cable for IBM
and compatible PC’s.
SCSI Port Accepts SCSI interface cable for
Macintosh computers.
Power Connector Accepts IEC standard three-pin power
cable.
Switchable Voltage Selector Automatically selects 110VAC or 220VAC.