Repair manual

3-7
TROUBLESHOOTING
The following is a description of each of the selections on the menu of Gentest:
<F1> View Image File - allows user to select and display Gentest
Images on Digitial Palette CRT for alignment purposes.
(Refer to Page 5-7 for complete procedures).
<F2> Expose Gentest Image - allows user to expose availiable
Gentest Images.
<F3> Expose Targa Image - allows you to expose available Targa
Images.
<F5> Reverse Video On - reverses current image displayed, i.e.
black changes to white, white to black.
<F6> Erase Digital Palette CRT - removes the current displayed
image from CRT.
<F7> Full White Screen - Applies full white screen to Digital Pal-
ette CRT.
<F8> CRT Off/On - allows user to turn CRT off and on.
<F9> Test and adjust Menu - There are three parts to this option,
one, <F1> Camera Adjust Menu allows you to zoom and to
add X and Y offsets to your image. The second part, <F2>,
AutoLuma Adjustment is used for AutoLuma Calibration.
(Refer to Page 5-7 for the complete procedure.) Finally
<F8> sets AutoLuma Table - this initiates a self calibration
mode of the Digital Palette.
<F10> See Parameters - allows user to set environment of Digital
Palette from the following:
<F1> Film Type
<F2> Lighten / Darken
<F3> Filter Position
<F4> See Expose Queue Mode
<F5> Set Exposed Buffer Mode
<F6> See AutoLuma Mode
Status Information Displays Current settings and conditions of the Digital Palette.
(Refer to Figure 1 on Page 3-4.)