Repair manual

3-6
TROUBLESHOOTING
C: Digital Palette Gentest
Digital Palette Gentest is a menu driven software tool that allows alignment and calibration of the
Digital Palette System. To use Gentest you will need the following tools:
Description Tool #
Digital Palette Gentest Software 13437
IBM-XT or IBM-AT or compatible (IBM-AT is perferred)
To initiate Gentest from the diskette, type "DPALETTE", This will initiate a batch file that will set
the environment for Gentest. There are two set commands contained in the Batch file. One sets the
parallel port to LPT1:, and the Digital Palette must be connected to that port. The second set com-
mand defines the location of the Gentest Images in subdirectory `A:\Images' on the diskette.
You can install this software on your hard drive if you choose, by adding these Set Command lines
to your AUTOEXEC.BAT file and reconfiguring the drive and port specifications.
The following Gentest Menu will be displayed after proper hardware and software communication
between computer and Digital Palette.
Digital Palette Manufacturing Gentest, Version 150
MAIN MENU STATUS INFORMATION
<F1> View Image File Film: *Type 669 (type11)
<F2> Expose Gentest Image Image: (Not Displayed)
<F3> Expose Targa Image CRT ON Normal Video
LD Value: 3 (Normal)
<F5> Reverse Video On Filter Position: 4 (Clear)
<F6> Erase Digital Palette CRT Camera Zoom 0 X : 0 Y: 0
<F7> Full White Screen Luminant Setting: 255
<F8> CRT off AutoLuma: Check AutoLuma
<F9> Test/Adjust Menu Dark Current: 0
<F10> Set Parameters Buffer: Execute Command a. s. a. p.
<ESC>EXIT to DOS Queue: Expose Multiple Images
Select an Item from the Main Menu
Figure 1