MS 4150 RS MP3

The “INITIALISATION” menu
☞
Select “Initialisation” in one of the following
menus: “RADIO”, “INFORMATION”, “CD” or “CD
CHANGER”.
:
The “INITIALISATION” menu is displayed.
The “INITIALISATION” menu allows you to adjust the
navigation radio to your needs.
The following functions are available:
Telephone
☞
Adapt your unit’s telephone input to your car phone:
–
NONE: No car phone is connected to the unit.
–
MUTE: Playback on the current source is automatically interrupted when your car
phone is in use. For this purpose, the car phone’s muting signal must be connected
to the device (see installation instructions).
–
IN: Playback on the current source is automatically interrupted and the incoming
call is played through the car loudspeakers. For this purpose, the car phone’s
muting signal and audio output must be connected to the device (see installation
instructions).
Tel Signal:
☞
Adapt your unit’s telephone input to the muting signal of your car phone:
–
Low: Muting signal “active low”. Radio switches to mute at 0 V.
– High: Muting signal “active high”. Radio switches to mute at 12 V.
Tel. Level:
☞
Adapt the car phone’s volume to the navigation radio’s telephone input.
✎
The volume adjustment can be set to between -30 and +30.
Beep Type:
☞
Select a confirmation/alert sound. You have the choice between 4 different sounds.
Beep Level:
☞
Set a level between 1 and 5 for the confirmation/alert sound.
Startup Vol.:
☞
This is where you set the maximum start-up volume, between 5 and 40.
✎
When you switch on the unit, the volume will always be set to this level if the
volume was louder than this level when you switched off.
Clock Settings
Setting the time format and the time zone:
–
Clock Format: Select between 12 or 24 hour format.
–
Timezone (only for GPS clock): Set the time difference to UTC (equivalent to
Greenwich Mean Time, London).
k
INITIALISATION
37
English
INITIALISATION
Beep Level: 1
Startup Vol.: 32
On Off Logic
Clock Settings