Specifications

GB
C
15
11
13. Set-up mode
Your VDO CYTEC C 15 features the following set-up procedures
wheelsize 1 = WS1 set-up starts out of TRP in display
wheelsize 2 = WS2 set-up starts out of TRP in display
clock = CLK set-up starts out of CLK in display
odometers = ODO1,ODO2 set-up starts out of ODO1, ODO2 in display
Trip Counter=TCNT set up starts out of TCNT in display
No matter which set-up mode is used for your VDO CYTEC , the procedure is the same.
You can start the set-up mode for a certain display by pressing the MODE 1 button for 5 sec. With this MODE button you may
also exit the set-up mode at any time.
Once the set-up mode is activated, MODE 1 and MODE 2 buttons are covered with following instructions:
MODE1 changing from one enter display to the next enter display
MODE2 selection of figure to be entered, changing from KMH to MPH mode
14. Selecting the wheelsize
Your VDO CYTEC C 15 can work with two different wheelsizes (WS1 or WS2), i.e. one wheelsize for your road bike the other
one for your mountain bike. When using the respective bike you can just switch to the proper wheelsize.
Wheelsize is only selectable if any of the following information is displayed: AVS-RID-STP-MAX
The currently active wheelsize is indicated in the display by WS 1 or WS 2. You can switch from wheelsize 1 (WS 1) to
wheelsize 2 (WS 2) and vice-versa by pressing the MODE 1 button for 5 sec.