Instruction manual

19
GB
MC
1.0
6.2 Correction of actual altitude
While you ride, the airpressure changes due to your gain in altitude as well as due to a wether change.To correct that influence of the wether change you
can also adjust the actual altitude display at your MC 1.0.Should you see a sign indicating actual altitude and should this altitude differ from the display
readout at your MC 1.0, you can manually correct the actual altitude.
Step 1: Get any of the ALTI-informations in display
Step 2: Press the ALTI-button for 3 sec, the display will show “ENTER REAL ALTITUDE” and the actual value of the altitude.
Step 3: MODE 1 will decrease the value , MODE 2 will increase the value.
Step 4: After you have entered the corect real altitude, you leave the setting procedure by pressing ALTI-button for 3 sec.
7. Troubleshooting
This chart outlines possible malfunctions, their causes and removal.
malfunctions most likely cause removal solutions
irregular LCD readout computer software is not press AC-button at the rear of computer head to reset 
(i.e. after battery change) running smoothly
speed display does not appear check for proper distance between readjusting distance between sensor 
sensor and magnet and magnet. 
cable from sensor to computer broken  check cable and replace if necessary.  
computerhead is incorrectly twisted on  place computerhead on handlebar 
handlebar holder holder and twist until detent (CLICK) 
no wheelsize entered enter your wheelsize
Display fades or disappears battery in computer empty check battery and replace if necessary.
temperatures below -15°C (40°F) Back in normal temperatures, display picks up working correctly. 
dull display readout
No altitude readout  computer in sleep-mode, not activated press any button to activate computer
No altitude climbed indication no speed impulses processed see infomation "no speed display" above