Specifications

INSTRUCTION AND MAINTENANCE MANUAL
The drawings and the technical data are R.M. S.p.a. - © R.M. S.p.a. - Revision 01.01.200732/44
WARNING
GENERAL MAINTENANCE REGULATIONS
All maintenance and repair work must be done by expert and specialist personnel.
All service engineers must work in full compliance with industrial accident prevention regulations. They must
wear suitable protective clothing. In this context, refer to the section on “GENERAL SAFETY NOTICES”, part of
the “INTRODUCTION” to this manual.
MAINTENANCE PLAN
Maintenance to be Description Product to be used
effected every:
300 h Greasing of hoseguide screw Grease for agricultural machinery
300 h Greasing of rotation's turntable Grease for agricultural machinery
300 h Greasing of wheel's housing - water inlet side Grease for agricultural machinery
300 h Greasing of teeth welded to the wheel Grease for agricultural machinery
300 h Greasing of ratchet stop dog Grease for agricultural machinery
see manuf.instruct. Greasing of sprinkler Grease for agricultural machinery
300 h Lubrication of by-pass valve's shaft with
manual oil feeder SAE 90EP/PP 80 oil
300 h Lubrication of transmission side chain between
wheel and hoseguide with manual oil feeder SAE 90EP/PP 80 oil
1000 h and Replacement of gearbox oil (check the
min. every 2 years level every 300 h) about 6 lt. SAE 90EP/PP80 oil
1000 h and Replacement of hydraulic system's oil (only for
min. every 2 years models with Briggs & Stratton engine with
oil tank) about 12 lt HP68 hydraulic oil
20 h Turns multiplying oil of compressor for
emptying (where mounted) see table on voice "compressor"
CHECKING OF SCREW COUPLINGS (to be effected with a dynamometrical key)
Coupling Screw Key Tightening moment
delle viti measurements (mm)
Tyres nuts (550-560) 19 300 Nm
Tyres nuts (570 -> Major) 27 300 Nm
Screw for fixing of tyres axle 22 150 Nm
Rotation's turntable M14 22 150 Nm
Screws for fixing of gearbox to
the chassis M10 17 65 Nm
CHECK TYRES NUTS AFTER 20 H OF WORK.