Specifications

INSTRUCTION AND MAINTENANCE MANUAL
The drawings and the technical data are R.M. S.p.a. - © R.M. S.p.a. - Revision 01.01.200726/44
DANGER
WARNING
Reeling in with the PTO shaft will not stop automatically and therefore this operation
must be done with the utmost care and attention.
Do not use the crank handle when the hose is reel out for more than 1 m because handle
spring back, caused by the elasticity of the hose, could cause serious injury to operator
limbs.
To ensure your safety, do not aim the water jet towards high voltage lines. Always check
to make sure that the jet is never directed towards houses, paved roads, electric cabins,
etc.
You will be held liable for any damage done if there is a power down or other problems
caused by your irrigation work.
USING AND REGULATING THE SPRINKLER
Follow meticulously manufacturer instructions. You will find these in the spare nozzle box.
FAST HOSE EMPTYING AND REWIND
To empty the hose, it should be unwound for not more than 50% of its length following the instructions given in the
section on “UNREELING THE HOSE”.
Reel the hose back with the PTO (pos. 8 photo H) with the gear unit lever in the disengage position (lever pos. 7
photo 7 towards right) and remove the drain plug on the carriage.
If the drain plug is not installed, remove the rain gun.
The hose must be reeled in exclusively with the PTO running at 540 Rpm at low speed and a sufficiently long PTO
shaft for max. 30 Hp transmitted power.
When the rain gun carriage is close to the end travel bracket and the hose reeled out 1 m, it must be reeled in
completely with the requisite crank handle (pos. 1, photo D).