Specifications

C2-6104A OPERATION MANUAL

14 CONNECTOR PINOUTS

14.1 DVI-I connector

PIN# SIGNAL PIN# SIGNAL

1 T.M.D.S DATA 2- 16 HOT PLUG DETECT

2 T.M.D.S DATA 2+ 17 T.M.D.S DATA 0-

3 T.M.D.S DATA 2/4 SHIELD 18 T.M.D.S DATA 0+

4 Not used 19 T.M.D.S DATA 0/5 SHIELD

5 Not used 20 Not used

6 DDC CLOCK 21 Not used

7 DDC DATA 22 T.M.D.S CLOCK SHIELD

8 ANALOG VERT. SYNC 23 T.M.D.S CLOCK+

9 T.M.D.S DATA 1- 24 T.M.D.S CLOCK-

10 T.M.D.S DATA 1+

11 T.M.D.S DATA 1/3 SHIELD C1 ANALOG RED

12 Not used C2 ANALOG GREEN / CV

13 Not used C3 ANALOG BLUE

14 +5V POWER C4 ANALOG HORZ SYNC

15 GND C5 ANALOG GROUND

14.2 RS232 / RS485 / RS422 D9 socket

Pin RS-232 RS-422

Full duplex

RS-485

Half-duplex

1 - TX- (from unit) A (link to pin 9)

2 TX (from unit)

3 RX (to unit)

4 - RX+ (to unit) B (link to pin 6)

5 GND GND GND

6 - TX+ (from unit) B (link to pin 4)

7 CTS (to unit)

8 RTS (from unit)

9 - RX- (to unit) A (link to pin 1)

‘To unit’ means signals are coming from a controller and being received by the unit.

‘From unit’ means signals are coming from the unit and being sent to a controller.

RS-422 may require termination across the RX+/- pins (usually 120 Ohm).

RS-485 needs pins linked as shown and may require termination across the A/B

pins (usually 120 Ohm).

You can select the serial standard in the ‘System’ menu.