User guide

Chapter 7 Configuring the Receiver
VideoJet 10 99
Gateway IP address:
Enter the IP address of the gateway here if the unit is to establish a connection
to a unit that is in another subnet. Otherwise, this field can remain empty (0.0.0.0).
Video/audio transmission:
If the device is used behind a firewall, TCP (HTTP port) should be selected as
the transmission protocol. For use in a local network, choose UDP.
Warning!
Multicast operation is possible only with the UDP protocol. The TCP
protocol does not support multicast connections.
Note
In UDP mode the MTU is 1514 bytes.
Ethernet link type:
If the VideoJet 10 is connected to the network via a switch, both devices must be
set for the same type of network connection. If necessary, ask your network
administrator about the switch setting.
Choose Auto for an autosensing network connection. If necessary you can set
the value to 10 or 100 MBit/s and full or half-duplex mode (FD or HD).
Warning!
Errors such as picture interference can occur if the network capacity is not
suitable for transmission of the maximum data rate generated by the
VideoJet 10.
Dynamic DNS server IP address:
When operating a unit over the Internet, an address pool with dynamic addresses
is used for greater efficiency. This means that the unit is assigned an IP address
each time a connection is made and this address varies. In this case, access is
easier if the unit is listed on a DNS server. It will contact the server at regular
intervals and register its unit name and IP address. To connect to the VideoJet 10
via the Internet, it is enough to enter the unit name and the URL of the DNS
server. The server returns the current Internet IP address for the connection.