User guide

Configuring the Receiver Chapter 7
98 VideoJet 10
Network
The settings on this page are used to integrate the unit into an existing network.
Warning!
Changes to the IP address, subnet mask or gateway address are sent to
the unit when the Set button is clicked. However, they only take effect after
the unit is restarted!
– Click Set after entering a new IP address.
– Enter the old IP address in the address field of the Web browser and append
/reset to it (e.g. 192.168.0.2/reset). The VideoJet 10 will be restarted
after which it can only be accessed at the new IP address.
Unit IP address:
Enter the desired IP address for the VideoJet 10 in this field. The IP address must
be valid for the network.
Subnet mask:
Enter the subnet mask corresponding to the inserted IP address here.
Gateway address for:
Select here if the gateway address is to be used for connections over LAN or
WLAN.