User guide

Configuring the Receiver Chapter 7
94 VideoJet 10
You can choose various events that activate the output automatically. Thus, for
example, it is possible to switch on a spotlight in response to a motion alarm and
switch it off again when the alarm situation is no longer active.
Idle state:
Select Open if the relay is to operate as a normally open contact or Closed if it
is to operate as a normally closed contact.
Operating mode:
Select an operating mode for the relay.
If, for example, a light switched on by an alarm is to remain lit when the alarm has
ended, select Bistable. If an audible signal activated by an alarm is to sound for
a period of ten seconds for example, select 10 sec.
Relay follows:
Select a particular event to trigger the relay. The following events can activate the
relay:
] Off
No relay triggering by events
] Connection
Triggering caused whenever a connection is established
] Local input 1
Triggering caused by the alarm input 1
] Remote input 1
Triggering caused by a relay contact at a remote location (only when a
connection is established)
Relay name:
A name can be assigned to the relay in this field. The name will be shown on the
button under Trigger relay.