User guide

Chapter 7 Configuring the Receiver
VideoJet 10 93
Destination IP address:
For each number, enter the corresponding IP address of the desired remote unit.
Destination password:
Enter the password, if the remote unit is protected by a password.
Remote encoder line:
If the remote unit is a multi-channel device enter here the number of the video
input which is to be the data source.
Auto-connect:
Select On if an active connection should be reestablished automatically to one of
the previously specified IP addresses after each restart, e.g. after a connection
breakdown or network dropout.
Relay
You can configure the switching behavior of the relay output. Relay action can be
specified either as open switch (normally closed contact) or closed switch
(normally open contact).
It is also possible to specify whether the output signal should be bistable or
monostable. With bistable operation, the relay remains in the activated state.
With monostable operation, the delay time can be selected after which the relay
reverts to its idle state.