User guide

Configuring the Receiver Chapter 7
92 VideoJet 10
Alarm connections
You can select a number of options for the response of the VideoJet 10 to an
alarm. In case of an alarm, the VideoJet 10 can establish a connection to a
predefined IP address, e.g. a VideoJet 10 sender, automatically. You can enter
up to 10 IP addresses which will be selected in sequence by the unit until a
connection is established.
Note
Sender and receiver must share the same subnet for connection set-up
(see page 98).
Connect on alarm:
Select On for the VideoJet 10 to establish a connection automatically to a
specified IP address in the event of an alarm.
With the setting Follows input, the VideoJet 10 holds the automatically set up
connection to a remote location as long as an alarm signal is present at its alarm
input 1. You can use this setting to establish a connection between two
VideoJet 10 units via a connected on-off switch. In this case you don’t need a
computer to set up the connection.
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.