User guide

Configuring the Sender Chapter 6
62 VideoJet 10
trigger unintended responses from the video sensor and generate false
alarms. Run a series of tests under day and night conditions to ensure that
the sensor works as intended.
For indoor surveillance, ensure constant lighting of the areas during the day
and at night.
Uniform surfaces without contrast can trigger false alarms even with
constant lighting.
Note
Clicking the Defaults button will reset the video sensor to its factory
configuration.
Motion detector
Select On to activate the video sensor.
Select sensor fields
The areas of the image to be monitored by the video sensor can be selected. The
video image is subdivided into 396 square sensor fields. Each of these fields can
be activated or deactivated individually. If it is necessary to exclude particular
regions of the camera's field of view from monitoring due to continuous
movement (by a tree in the wind, etc.), the relevant fields can be deactivated.
– Click Select area to configure the sensor fields. A new window will open.
– If necessary, click Clear all first to clear the current selection (fields marked
red).
– Left-click the fields to be activated. Activated fields are marked red.
– Click Select all to select the entire video frame for monitoring.
– Right-click any fields you wish to deactivate. "Inactive" fields are marked white.
– Click Set to save the configuration.
– Click the close button (X) in the window title bar to close the window without
saving the changes.