User guide

Chapter 6 Configuring the Sender
VideoJet 10 59
Motion detection is configured on a separate page (see page 61).
Alarm input 1:
Select the option On in order to activate the alarm via the external alarm sensor.
Otherwise, select Off.
Choose Active high to trigger the alarm closing the contact. Choose Active low
to trigger the alarm opening the contact.
Name:
You can enter a name for the alarm input, which is then displayed next to the icon
for the alarm input on the video live page when configured accordingly (see
page 78).
1./2. SNMP host address:
Enter the IP addresses of up to two chosen receivers here if SNMP-traps are to
be sent.
Alarm connections
You can select a number of options for the response of the VideoJet 10 to an
alarm. In case of an alarm, the VideoJet 10 can establish a connection to a
predefined IP address (VCS hardware receiver or PC with receiver software)
automatically. You can enter up to 10 IP addresses which will be selected in
sequence by the unit until a connection is established.