User guide

Chapter 6 Configuring the Sender
VideoJet 10 53
Once started, the Time recording and Alarm recording pages and the settings for
the active partition are shown in grey and the configuration cannot be changed.
The icon at the bottom of the pages indicates recording activity on this partition.
The icon is animated while recording is in progress.
Recording activity can be stopped at any time, and the partition can be
deactivated.
– Click Start to activate the currently selected partition for recording.
– Click Stop to deactivate the currently selected partition for recording.
Recordings in progress are interrupted and the configuration can be changed.
Note
While a partition is active you cannot change the configuration for any
partition neither using the Partitioning page nor the page Recording
scheduler.
Time recording
Here you can specify the times during which continuous recording to the storage
medium will take place.
For each partition, there are separate selection fields for each day of the week.
You can select 16 individual recording periods for each day of the week.
Note
If a period has already been selected for alarm recording, you cannot select
this period for the time recording (see Alarm recording, page 54).
– Left-click on the point in the schedule at which recording should start and hold
down the mouse button.
– Now drag the selected field to the desired end time for the recording and
release the mouse button.
– Right-click a selected time segment to delete it.
– Click Select all to select all time segments.
– Click Delete all to delete all selected periods.