User guide

Configuring the Sender Chapter 6
50 VideoJet 10
– Click in the text fields to enter values or use the other controls available, such
as buttons, check boxes or list fields.
– Click Next >> to continue to the next step.
– Click << Back to look at the previous step again.
– Click Cancel to interrupt the process and close the Wizard.
Making changes
Once you have specified all the settings you want, they must be transferred to the
VideoJet 10 and saved. Click Finish on the last screen of the Wizard to complete
this process.
Warning!
All changes to the settings will only take effect after you have ended the
configuration by clicking Finish in the last screen.
– Go to the last screen of the Wizard if necessary.
– Click Finish to finalize the configuration. All settings will be transferred to the
VideoJet 10 and are then effective.
Editing a partition
The configuration of a partition can be changed at any time.
Warning!
Making changes to a partition causes the affected partition to be
reorganized and all sequences stored on it to be lost.
Changes to the size (total space in partition) will result in reorganization of
the entire storage medium and the loss of all saved data.
You should therefore back up all important sequences to the computer's
hard drive before making changes to the partition.
The desired changes can be made in the Edit partition window.
– Click to select the partition in the list that you want to change.
– Click Edit partition. A new window is opened containing information about the
selected partition.