User guide

Chapter 6 Configuring the Sender
VideoJet 10 45
Audio stream
In addition to video data, the unit can also send and receive audio signals. The
transmission of audio takes place at the same time as that of the video data in a
separate data stream. Thus it increases the data traffic. The audio data is coded
according to G.711 compression standard and requires an additional bandwidth
of about 80 kBit/s per direction.
Warning!
G.711 audio data is only saved with central recording, using VIDOS-NVR
for example.
Enable audio:
To transmit a separate G.711 audio stream choose On.
Video input
The VideoJet 10 can alleviate a possible noise in the video signal using various
input filters. This lowers the data rate and is an advantage especially with low
bandwidth. However, picture sharpness is affected when a filter is used. The filter
should be chosen dependent on the picture quality required.
Video input filter:
Choose None to use no filter for the video input. Choose Low, Medium or High
to set a corresponding filter.