User guide

Installation Chapter 4
20 VideoJet 10
Connections
Camera/monitor
Depending on the device used, you can connect a video source (sender) or a
monitor (receiver). All cameras and video sources that generate a standard PAL
or NTSC signal and all monitors compatible with PAL or NTSC standards can be
used for this purpose
– Connect the camera or another video source using a video cable (75 Ohms,
BNC plug) to the Video In BNC jack of the sender.
– Set the slide switch 75
Ω on the front of the sender to • to terminate the video
input when the video signal is not lopped through.
or
– Connect the video monitor using a video cable (75 Ohms, BNC plug) to the
Video Out BNC jack of the receiver.
Data interfaces
The bidirectional data interfaces are used to control equipment connected to the
VideoJet 10 unit, such as a dome camera with a motorized lens.
The COM1: RS232/485 connection supports RS232, RS422 and RS485
communication standards, the COM2: RS232 supports only RS232.
The serial interfaces are Sub-D sockets. For information on the pin assignment
see page 136.
The selection of controllable devices is growing constantly. The manufacturers of
this equipment can provide specific information on installation and control.
Warning!
Make use of the device documentation when installing and operating a
device that you want to control using the system. It contains important
safety instructions and information about authorized use.
Note
A video connection is necessary to transmit transparent data.