User guide

Maintenance and Upgrades Chapter 12
132 VideoJet 10
– If necessary, back up the current settings using the Download button on the
configuration page entitled Firmware and configuration upload (see page
81 for sender and page 104 for receiver).
– Use a pointed object to press the reset button which is found below the
CompactFlash interface (see page 16) until the LED I is lighting red. All
settings will revert to their defaults.
– Change the IP address of the unit as necessary.
– Configure the unit to meet your requirements.
Repairs
Warning!
Never open the casing of the VideoJet 10 device. The unit does not contain
parts that you can repair or replace.
Ensure that maintenance or repair work is performed only by personnel qualified
in electro-technics and network technology, or contact your VCS dealer service
center.
Transfer and disposal
The VideoJet 10 should only be passed on together with this manual.
The unit and its power supply contain environmentally hazardous materials that
must be disposed of according to law.
Defective or superfluous units and parts should be disposed of professionally or
taken to your local collection point for hazardous materials.