User guide

VideoJet 10 131
Maintenance and Upgrades 12
Testing the network connection
The ping command can be used to check the connection between two IP
addresses. This allows you to test whether a unit is active in the network.
– Open the DOS command prompt.
–Type ping followed by the IP address of the unit.
If the unit is found, the response appears as Reply from ..., followed by the
number of bytes sent and the transmission time in milliseconds. Any other
response indicates that the unit cannot be accessed via the network. Possible
causes:
] The unit is not properly connected to the network. Check the cable
connections in this case.
] The unit is not correctly integrated into the network. Check the IP address,
subnet mask and, if necessary, the gateway IP.
Device reset
The reset button can be used to reset the unit to its original factory settings. Any
changes in the settings will be overwritten by the factory defaults. This may be
necessary, for example, if the unit has invalid settings that prevent it from
functioning as desired.
Warning!
All configured settings will be discarded during a reset. If necessary, back
up the current settings using the Download button on the configuration
page entitled Firmware and configuration upload (see page 81 for
sender and page 104 for receiver).
Note
After a reset, the unit can only be addressed via the factory default IP
address. The IP address can be changed as described in the chapter
entitled Installation (see page 25).