User guide

Hardware Connections Chapter 10
126 VideoJet 10
Connection when an alarm signal is given
Sender and receiver can be configured to connect automatically with each other
when an alarm is triggered (see page 59 for sender and page 93for receiver).
After a short time, the live video image from the sender will be shown on the
connected monitor.
This option can also be used to connect two VCS units via an on-off switch at the
receiver. In this case, a computer is not needed to establish the connection (see
page 92).
Connection using a terminal program
This operating mode has various prerequisites. Refer to the section Setup using
terminal software (see page 24).
– Start the terminal program. Enter the command i to call up the IP menu.
– Enter the command r in the IP menu to change the remote IP address, then
enter the IP address of the device to connect to.
– Enter the command a in the IP menu to activate automatic connection set up.
Connection using a Web browser
This operating mode has various prerequisites. Refer to the section Establishing
the connection (see page 27).
– Use the Web browser to connect to the VideoJet 10 receiver. Its home page
will be displayed.
– Establish the desired connection to the monitor (see page 123).