User guide

VideoJet 10 125
Hardware Connections 10
Hardware connections between VCS units
A VideoJet 10 sender, connected to a camera, and a VideoJet 10 receiver,
connected to a monitor, can be linked together or to other VCS units easily via an
Ethernet network or a wireless LAN. This makes it possible to establish
connections over large distances with little effort for installation or cabling.
Installation
The VCS units are designed to connect with one another automatically when
correspondingly configured. The only requirement is that they are both part of a
closed network. Proceed as follows to install the units:
– Connect the units to the closed network using Ethernet cables or wireless LAN
cards.
– Connect them to the mains supply.
Note
Make sure the units are correctly configured for the network environment
and that the correct IP address of the remote unit that is to be connected in
case of alarm is set on the configuration page Alarm connections (see
page 60 for the sender and page 93 for the receiver).
Establishing the connection
There are three options for establishing a connection between a VCS sender and
a VCS receiver in a closed network:
] when an alarm signal is given,
] using a terminal program or
] using a Web browser