User guide

Chapter 7 Configuring the Receiver
VideoJet 10 105
After the upload is completed successfully, the unit will restart automatically.
If the LED Power is red, the upload has failed and must be done again. This
requires that you work from a special page:
– Enter the IP address of the unit in the browser and append /main.htm (for
example 192.168.0.12/main.htm).
– Repeat the upload.
Configuration download:
The VideoJet 10 configuration data can be saved on a computer and the saved
data loaded on a unit from the computer.
– Click Download. A dialog will appear.
– Follow the instructions to save the current settings.
Configuration upload:
– Enter the full path of the file to upload or click Durchsuchen... to select the
desired file.
– Make sure that the file to be loaded originates from the same type of device as
the unit you want to reconfigure.
– Click Upload to begin transmitting the file to the unit. Transmission progress
can be monitored from the progress bar.
After the upload is completed, the new configuration will be activated. The time
necessary is indicated by the message going to reset Reconnecting in ...
seconds.
After the upload is completed successfully, the unit will restart automatically.