User guide

Configuring the Receiver Chapter 7
104 VideoJet 10
Firmware and configuration upload
Firmware update:
The VideoJet 10 is designed in such a way that its functions and parameters can
be updated with firmware. To accomplish this, the current firmware is loaded on
the unit via the selected network. It will be installed automatically.
Thus a VideoJet 10 unit can be serviced and updated remotely without requiring
a technician to make changes on-site.
The current firmware can be obtained from VCS Customer Service or
downloaded from the Internet at our Web site (www.vcs.com).
Warning!
Before starting the firmware upload, be sure that you have selected the
correct file! Uploading the wrong files can result in the unit no longer being
addressable, requiring it to be replaced.
Do not interrupt the firmware installation for any reason! Interruption will
damage the flash EPROMs. This can also result in the unit no longer being
addressable, requiring it to be replaced.
– First, save the update file to the hard disk.
– Enter the full path for the update file in the field or click Durchsuchen... to
locate and select the file.
– Click Upload to begin transmission to the unit. Transmission progress can be
monitored from the progress bar.
The new firmware will be decompressed and used to reprogram the flash
EPROM. The time necessary is indicated by the message going to reset
Reconnecting in ... seconds.