User guide

Chapter 7 Configuring the Receiver
VideoJet 10 101
WLAN IP adress:
For connection via WLAN a dedicated WLAN IP address must be assigned to the
VideoJet 10. This IP address must refer to a subnet other than the Ethernet IP
address.
Enter here the IP address for the WLAN.
WLAN subnet mask:
Enter here the subnet mask referring to the WLAN IP address.
Network name:
In order of two devices being connected over WLAN they must belong to the
same WLAN.
Enter here the name (SSID) of the desired Wireless LAN.
WLAN port type:
Here you decide on the port type used for the WLAN connection:
] BSS (Infrastructure mode): Connection via Access Point
] IBSS (Peer-to-peer mode): Direct connection to another WLAN capable
device, e.g. laptop or VCS device
Channel settings:
Choose here the channel for the WLAN connection.
Note
Sender and receiver must use the same channel to enable transmission.
Access point density:
Enter here a value indicating the number of available Access Points. Choose
High if the number is large, Low if only a few Access Points are available.
WLAN encryption:
WLAN connections are not protected against unauthorized access. It is possible
to code the data with an encryption key for security.