User guide

Installation Chapter 4
24 VideoJet 8000
– Enter only one command at a time.
– After entering a value (such as an IP address), re-check the entry before
pressing the Enter key to send the data to the VideoJet 8000.
Assigning an IP address
To operate the VideoJet 8000 on a network, an IP address valid for the network
must be provided.
The following default address has been pre-set at the factory: 192.168.0.1
Note
The new addresses will only be in effect after restarting.
– Start up a terminal program such as HyperTerminal.
– First enter ? and then service as the user. The main menu will be
displayed.
– Enter the command i twice, in order to open the IP menu and then display the
current IP address.
– Enter the desired IP address and press Enter. The new IP address will be
shown.
– If necessary, enter the command s and a new subnet mask.
– Interrupt the power to the VideoJet 8000 briefly (pull the power plug and
replace it after a few seconds) to restart the unit.