User guide

Configuration using a Web Browser Chapter 5
102 VideoJet 8000
Stop bits:
Select the number of stop bits per character.
Parity check:
Select the type of parity check.
Interface mode:
Select the desired protocol for the serial interface.
Half-duplex mode:
Choose the setting appropriate for your application.
Network settings
The settings on this page are used to integrate the unit into an existing network.
Warning!
Changes to the IP address, subnet mask or gateway address are sent to
the unit when the Set button is clicked. However, they only take effect after
the unit is restarted!
– Click Set after entering a new IP address.
– To do this, enter the old IP address in the address field of the Web browser
and append /reset to it (e.g. 192.168.0.80/reset). The VideoJet 8000
will be restarted after which it can only be accessed at the new IP address.