Setup guide

Chapter 3 MeetingPoint Setup
VCON Desktop Systems Installation and Setup Guide 41
13. To save the setup and exit the Configuration Setup Wizard, click Finish.
The MeetingPoint program now starts, and the Conference Panel and the
Local Video Window appear.
To cancel the setup, click Cancel. In this case, all setup information will
be discarded and you will not be able to run MeetingPoint until you
perform the setup at another time.
3.5 Changing Configuration Information
After completing the Configuration Wizard the first time that you run
MeetingPoint, you can change the configuration information through the System
Properties dialog boxes. The System Properties are accessible from several
locations.
The table below describes the quickest way to access the configuration information
that you entered in the Configuration Wizard.
User Information In the Conference Panel, right-click and then click
Properties. In the Properties dialog box, click the User
Data icon.
LAN
or
T Double-click the Gatekeeper icon in the Conference
Panel tray.
-or-
T MXM-managed applications only
In the Conference Panel, click the Network arrow
and then click H.323 Properties.
If the system is not registered with a GateKeeper:
T In the Conference Panel, right-click and then click
Properties. In the Properties dialog box, click the
Communication icon.
Online
Directories
Non-MXM applications only
1. In the Conference Panel, click the Dialer arrow and
then click Properties. The Address Book
Properties dialog box appears with the General tab
open.
2. Click the Online Directories tab.