Setup guide

Chapter 3 MeetingPoint Setup
VCON Desktop Systems Installation and Setup Guide 27
Stand-alone System
³ To start MeetingPoint
1. In the Windows Desktop, click the VCON MeetingPoint icon.
The Conference Panel appears, followed by the Local Video window.
At this point, if the system’s communication lines are connected, you may
start a video meeting and receive incoming video meeting calls.
Conference Panel - Stand-alone MeetingPoint
Exiting MeetingPoint
³ To exit MeetingPoint
T Double-click the MeetingPoint icon at the far left side of the Conference
Panel.
-or-
Right-click anywhere in the Conference Panel and click Exit.
If you are running MeetingPoint for the first time after installation, the
Configuration Wizard setup program appears. This program asks you to
enter the information required to run MeetingPoint from your specific
location. For the complete standard setup procedure, see see “Setting Up The
MeetingPoint Configuration” on page 28.
MeetingPoint’s default properties are suitable for most video meeting
requirements. If you must change these settings, please consult with your
system administrator or VCON distributor.
If you are connected in a video meeting, a message asks you to hang up
before you exit MeetingPoint.