ASSEMBLY DIAGRAM PARTS LIST PARTS LIST PARTS LIST HARDWARE LIST NO| DESCRIPTION (QTY|NO| DESCRIPTION OTY |NO| DESCRIPTION [QTY|NO| DESCRIPTION |QTY Left sid u di Three-In-one 4*23; : Len side Q 1 (8) trove “J A jsmone™" Right sid mean 2 42H naps OC] 2] Clam () [42 T [ono ele] QO @ | Long front Drawers 840 Drawer and rear 2 bottom 21 |D wood dowel 22| J shaped 2 panel panel pins plastic Front middle Lower drawer Drawer panel 7 1 side panel NN 2 E slides pd 4 Upper back Lower drawer 4*16mm panel 1 rear panel
STEP 1 HARDWARE LIST Three-in-one connecting rod = B «42 PCS 1.Put the three-in-one connecting rod in the 1010mm hole of the following panels and tighten them with a cross screwdriver or an electric tool. 1.Strike the !008*40mm wood dowel pin into the {08m hole of the above panels with an iron hammer. Please note that the hole of the three-in-one connecting rod should also be 8mm. The hole of the three-in-one connecting rod connects to the hole of 115mm three-in-one eccentric wheel.
1.Fix the drawer slide to the side panel with 4*16mm screws. HARDWARE LIST Drawer slides E 74 PCS ¥ 1.Press the slide snap switch, disassemble slide blocks and put them in a place properly for further use.
1.Connect No. 3-4-5-6 panel to No.2 panel tightly with the three-in-one eccentric wheel. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one Three-in-one eccentric wheel | sticker ARTISTIC ()PCS i 1.Connect No. 1 panel to No. 3-4-5-6 panel tightly with the three-in-one eccentric wheel 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker.
STEP 7 1.Install the Drawer U-shaped plastic with 4*16mm screws. 1.Install No. 8-9-10-11 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one Three-in-one eccentric wheel sicker = A G14 PCs|C ()14 PCS Drawer U-shaped | 4*16mm screw plastic J e531 PCS | Fo” 10 PCS STEP 8 1.Install the drawer handle with 4*23 mm screws.
STEP 9 1.Install the Drawer U-shaped plastic with 4*16mm screws. 1.Install No. 7-11-12-13 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one Three-in-one eccentric wheel sicker = A G14 PCs|C ()14 PCS Drawer U-shaped | 4*16mm screw plastic J e531 PCS | Fo” 10 PCS STEP 10 mm Screws.
STEP S35 f=] & <& and press it forward to install the drawer. STEP 14 1.Install white angle bracket with 416mm screws.
Choking hazard-Small Parts : This unit contains small parts, not for children under 3 years. Tip-over hazard : Secure finished unit to wall stud using L-Bracket and wall screw provided). If a wall stud is not accessible, Consult your local hardware store for appropriate mounting hardware . Failure to properly install will result in product collapse or tip-over. Serious injury can occur .
