ASSEMBLY DIAGRAM PARTS LIST PARTS LIST PARTS LIST HARDWARE LIST NO| DESCRIPTION QTY{NO| DESCRIPTION [TY] [NO| DESCRIPTION QTY|NO| DESCRIPTION [atty Left side Left rear Three-Ln-one 5 416m panel 0 1 top-dom 1 |A eccentric 58 | F [screw Left rear Three-in-one Right side n 420mm panel 0 1 [2pm pr 1] |B connecting (58 | G screamer | 4 Oft, : Lower raver Three-in-one Drawer steamboat 1 anal [sticker andante & 2 right upper drawer, 840m wood Aluminum bottom 1 panel dowel pins 32| I tattoo feet b Drawer riddle sid
STEP 1 HARDWARE LIST Three-in-one connecting rod gr B 5 PCS 1.Put the connecting rod in the 10mm hole of the following panels and tighten them with a cross screwdriver or an electric tool. 1.Strike the 8%40mm wood dowel pin into the 8mm hole of the above panels with an iron hammer. Please note that the hole of the wood dowel pins should also be 8mm. The hole of the three-in-one connecting rod connects to the hole of 15mm eccentric wheel.
STEP 3 “Drawer slides snap switch STEP 4 L Fix the drawer slide to the side panel with 4%16mm screws. HARDWARE LIST Drawer slides E 7” PCS { L.Press the slide snap switch, disassemble slide blocks and put them in a place properly for further use.
& 1.Connect No. 4-6-7-8 panel to No.2 panel tightly with the eccentric wheel. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel A 9 PCS sticker C () PCs EE & 1.Connect No. 1 panel to No. 3-9-10-11-12 panel tightly with the eccentric wheel. 2.
STEP 7 1.Install the Drawer U-shaped plastic storage box with 4%16mm screws. 4 Bs, 1.Install No. 14-15-18-19 panels with the eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-is Three-i.
STEP 8 1.Install the Drawer U-shaped plastic with 4%16mm screws. 4 Bs, 1.Install No. 13-15-16-17 panels with the eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-is Three-i.
l.Lock the spare drawer slide block to the drawer. 2.Install the drawer handle with 4#20 handle screws. HARDWARE LIST 4%16nm screw Drawer slides Ho PCS 2 4%20mm screw Drawer handle G ¢® PCS | H ~~ PCS L Fix feet of the cabinet with 4¥16mm screws.
Choking hazard-Small Parts : This unit contains small parts, not for children under 3 years. Tip-over hazard : Secure finished unit to wall stud using L-Bracket and wall screw provided). If a wall stud is not accessible, Consult your local hardware store for appropriate mounting hardware . Failure to properly install will result in product collapse or tip-over. Serious injury can occur .
