ASSEMBLY DIAGRAM PARTS LIST PARTS LIST PARTS LIST HARDWARE LIST NO| DESCRIPTION QTY|NG| DESCRIPTION QTY |NO| DESCRIPTION QTY|NO| DESCRIPTION [TY Left side Front baffle Three-in-one — Door A 11: field panel Q 1 panel oF 1 |A sanserif fig 138 H | band glare om 0 1118 coming 2” 38| I [Bracken noe [J] elm) erm ©) we | boredom | om eu xin Gm ere Du) Lam 2 Lire] (6) smi [oer 80 | M nines (Born 2 G poi Cd 6 CAUTION: Please confirm the parts list before installation
STEP 1 HARDWARE LIST Three—in—one connecting rod 2 B « PCS L.Put the connecting rod in the &10mm hole of the following panels and tighten them with a cross screwdriver or an electric tool. STEP 2 1.Strike the ¢ 08%40mm wood dowel pin into the &8m hole of the above panels with an iron hammer. Please note that the hole of the three-in-one connecting rod should also be 8mm. The hole of the connecting rod connects to the hole of ¢ 15mm three-in-one eccentric wheel.
STEP 3 Drawer slides snap switch HARDWARE LIST Drawer slides E ~~ PCS & L.Press the slide snap switch, disassemble slide blocks and put them in a place properly for further use. L Fix the drawer slide to the side panel with 4%16mm screws.
1.Connect No. 3-4-5-6-7 panel to No.2 panel tightly with the eccentric wheel. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel A Bg PCS sticker Cc ( PCS = 1.Connect No. 1 panel to No. 3-5-6 panel tightly with the eccentric wheel. 2.
L Fix feet of the cabinet with 4*16mm screws. HARDWARE LIST 4%16mm screw Aluminum alloy leg 2 F ® PCS | K LJ] PCS 1.Install small angle bracket and reinforced middle partition.
STEP 10 1.Install No. 11-12-13-14 panels with the three—in—one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel A § PCS Three—in—one sticker C () PCS — 3.Lock the spare drawer slide block to the drawer.
STEP 11 = 1.Install No.8 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel | sticker Ag PCS |C () PCS i 1.Align slide block with the trough on the guide rail, press the snap switch and press it forward to install the drawer. 2.Install drawer handles.
STEP 13 1.Install the hinge cup to the door panel with 4¥16mn screws. 2.Install the hinge to the side panel with 4%16mm screws. 4.Adjust the door panel clearance. 3.Install the hinge HARDWARE LIST cup on the door 2¥16mm screw | Door hinge panel to the hinge 2 of the side panel. F o® PCS | M 258, PCS l.Install the door handle with 423mm screws.
Choking hazard-Small Parts : This unit contains small parts, not for children under 3 years. Tip-over hazard : Secure finished unit to wall stud using L-Bracket and wall screw provided). If a wall stud is not accessible, Consult your local hardware store for appropriate mounting hardware . Failure to properly install will result in product collapse or tip-over. Serious injury can occur .
