Instruction manual

Network Time Synchronization

These fields are used to synchronize network time using the host name or IP address of a

known server to provide a synchronized time for all appliances in the network. To enable

Network Time Synchronization after these parameters are set, go to Configuration: System >

General on page 76 and check the box.

Configuration: Network > Routing

The WM Appliance requires no routing configuration for the vast majority of network uses.

Use these settings only in those rare cases when your network requires advanced routing

features in the appliance.

Note Network Administrators please note. DHCP Option 4 is used by the DHCP server to

return SNTP server addresses. This option must be enabled in the DHCP server for

these addresses to be returned to the VBrick. If the DHCP server configuration is

unknown, it is recommended that the address(es) be manually entered since the

DHCP server-supplied address will always override a manually-entered address.

Primary Server IP

Address or Host Name

Primary host name (VBrick Host Name or DNS Host Name) or IP

address of valid SNTP server providing time synchronization. A

blank field indicates the server address will be acquired via the

DHCP server only if the

Network DHCP field above is checked.

Secondary Server IP

Address or Host Name

Secondary host name (VBrick Host Name or DNS Host Name) or

IP address of valid SNTP server providing time synchronization. A

blank field indicates the server address will be acquired via the

DHCP server only if the

Network DHCP field above is checked.