Instruction manual

Diagnostics
VBrick WM Appliance Admin Guide 117
Diagnostics: Hard Drive
T To run Check Disk:
1. Go to
Configuration: System > General.
2. Set the
Configured Operational Mode to Diagnostics. (After you press Apply, the
appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")
3. Go to
Diagnostic: Hard Drive and click Begin Edit.
4. Click
Start to run the utility. (Note that the Start button is only shown in Diagnostic
Mode.
5. Click
Refresh to see the results.
6. When done, reset
Configured Operational Mode to Run.
Hard Drive Format Use carefully. Removes all content and reformats the hard drive.
Check Disk Runs the Check Disk utility. You must be in Diagnostic Mode to
start Check Disk. See below.