User guide

10 EtherneTV Media Distribution System
Start Mode
MCS Location
Receive Address
Local UI Location
Home Page Location/Home Page Enable
Main Volume/Line 1 Volume
RTSP Streaming
Data Buffering Seconds
Buffer Check for Underflow
Lowest Bitrate for Buffer Check
Audio Data Port/Video Data Port/CC Data Port
RTP Data Port
Proxy Type, HTTP Proxy Host and Port
Options Panel Login
Aux1–Aux8
Start Mode
The EtherneTV STB can operate in one of three modes described here. Use MCS mode if
there is an ETV Portal Server (formerly MCS) installed on your network. Otherwise you must
select
Local or Local-Full Screen mode.
MCS Location
MCS Use if the installation includes the EtherneTV Portal Server.
Local Use if the installation does not include the EtherneTV Portal Server.
If Local, the site administrator must configure the Program Guide.
See Local Configuration on page 21 for more information.
Local-Fullscreen Use if the desired operation is to set the unit to decode one channel
and operate in full screen mode at boot up. If you select Local-Fullscreen
mode, you must also enter a Receive Address; see below.
MCS Location When the start mode is configured for MCS, this parameter
determines the IP address of the ETV Portal Server that the STB will
obtain its program listing information from. Enter the IP Address of
the portal server. The format is
172.12.12.12.